What FUSE do I need for my pond pump?
3 Amp fuse
Pond Electrics – Fuses – Bradshaws Direct. = 3ATherefore, the pump will require a 3 Amp fuse. When calculating a fuse for a junction box you must use the total sum wattage rating for all the appliances which are running off the fuse.
Why is my UV pond light not working?
If it is not working the lamp is bad, the ballast is bad, or there is an electrical problem. Each ultraviolet sterilizer has a rating for the pond size it will handle and the maximum flow rate it can handle. The maximum pond size can be exceeded, but will reduce the clarity level.
What AMP are pond pumps?
A 4,000 GPH pond pump will draw between 10 and 15 Amps, depending on the brand.
What is a 5 amp fuse used for?
5 amp sockets are used on the lighting circuit, meaning they are switched on and off with the light switches in the room, rather than being used like regular plug sockets. They are designed for appliances that take less than a 5 amp current, for example floor lamps, table lamps and fans.
Does UV light go before or after filter?
Generally, the better, and most common, placement is right after the filter. In fact, a lot of the biological filters (that have a uv light built in) place this uv light after the filter itself. There are a couple of good reasons for this: The uv light works more efficiently when the water flowing along it is clearer.
Do UV lights stop working?
The frequency of changing a UV lamp for effective indoor air quality improvement depends on how you are using the system. Typically, a UV lamp being used primarily to disinfect the air circulating through a home or small office should be replaced every 9000 hours or approximately every 12 months.
Why does my pond pump keep blowing a fuse?
Leaking. One common cause of a submersible pump tripping its breaker can be cracks or leaks in the housing. If your pump’s housing is cracked, water could be getting into the pump through these cracks and causing it to short circuit. The same can be happening if you have a leak in your pump which is letting water in.
What FUSE do I need for a water feature?
4 Answers from MyBuilder Electricians You will have to install a fused spur and lower the 13amp fuse to a 3amp to follow there guidelines.