What are the pins on a SATA drive?
A jumper pin is a rectangular connector that creates a circuit between two pins. Seagate SATA drives have four pins, while Western Digital SATA drives have eight pins, with the additional pins to be used by technicians or your network administrator for powering up the drive while in standby mode.
What are the pins on 2.5 drive?
2.5″ SATA SSD and Slim SATA (MO-297) Connector There are a total of 22-pins broken into 7-pins for Data and 15-pins for Power. The contact pads for these products is only found on one side of the connector.
Are SATA and PATA interchangeable?
Compatibility between SATA and PATA As for compatibility, there is none. SATA and PATA drives are completely incompatible at the interface. They can certainly co-exist in a machine, but only if that machine has both SATA and PATA interfaces.
Are PATA and IDE the same?
IDE and PATA are two terms that people typically get confused over since they are used in referring to pretty much the same hard drives. Although it might seem like there should be some difference between the hardware identified by the two, when it comes to hard drives, there is actually no difference.
What is the 4 pin on a hard drive?
4-pin power (5.25 inch) A computer’s power supply normally provides several of these connectors, which mate to male interfaces on hard drives, CD/DVD drives, and other internal devices. Because these drives often have a 5.25 inch form factor, the power connector itself became known as a “5.25” connector.
What are the 8 pins on my hard drive?
They’re actually jumper pins. You may enable particular settings by placing a jumper shunt onto specific pins—creating an electrical circuit between them. The settings these jumpers enable are hard-coded onto a drive’s programmed printed circuit board.
What are the 3 connections on a HDD?
There are three main types of cables: IDE/PATA, SATA and SCSI.