How many teeth does a mini bike clutch have?
Made in the USA. The 12 Tooth Clutches use 35 Chain. The 10 Tooth Clutches use 40,41 and 420 Chain. Made in the USA.
How do you adjust a centripetal clutch?
- Step 1 – Loosen the Set Screws. Firstly, loosen the set screws of your clutch.
- Step 2 – Loosen the Crankshaft Bolt. Now, loosen the bolt that runs perpendicularly to the clutch, into the crankshaft.
- Step 3 – Reposition the Clutch.
- Step 4 – Tighten the Set Screws and Bolt.
How do you adjust a centrifugal clutch on a mini bike?
If your centrifugal clutch needs adjustment, follow the steps below….
- Step 1 – Loosen the Set Screws.
- Step 2 – Loosen the Crankshaft Bolt.
- Step 3 – Reposition the Clutch.
- Step 4 – Tighten the Set Screws and Bolt.
Do you need to oil your clutch?
Both the clutch and the chain need daily lubrication. The clutch contains an oil impregnated bronze bushing. 15% of the weight of the bushing is the oil that is impregnated into the bushing by the manufacturer. This oil can leak out, or can evaporate over time, and must be replaced.
How long does a mini bike clutch last?
However, if it’s improperly installed, driven in abusive conditions (sand, steep terrain, excessive weight in the kart or rear tires taller than 15”), the clutch might only last 20 minutes. Karts with rear tires taller than 15” or an engine larger than 8-hp require a torque converter.
Can you operate a mini bike without a clutch cover?
Operating the mini bike without the clutch cover in place could be Hazardous. Operating the mini bike without the clutch cover could result in getting body parts or loose clothing caught in moving parts which could result in severe injury. Never Start or operate the mini bike without the clutch cover in place.
How do I tighten the chain on my Mini Bike?
Adjust chain tension by turning the tension nuts (3) (Note: tension nuts are located on both sides of the mini bike.) Clockwise will tighten the chain. Counter clockwise will loosen the chain. 3. Once the chain is at the correct tension re-tighten axle bolt (2). 4. Re-check chain tension. 1
How do you lubricate a centrifugal clutch?
Lubricate Centrifugal clutch (2) using the same type of motor oil that is used in the engine. Place a few drops of motor oil on the drive shaft (3) where the clutch is attached. Do not oil any other portion of the clutch. DO NOT PLACE ANY OIL IN THE LARGE HOLES IN THE CLUTCH. THE HOLES ARE FOR AIR CIRCULATION ONLY.
Can I operate my mini bike with improper tire sizes or pressure?
Operating this Mini Bike with improper tire sizes or pressure could be hazardous Operating this Mini Bike with improper tire sizes or pressure could result in loss of control of the Mini Bike which could result in an accident. Never operate this Mini Bike with improper tire sizes or pressure.