Why is my Whirlpool dehumidifier not working?
If the control board is defective, the dehumidifier will not run. The humidity sensor monitors the level of moisture in the air. When the moisture level is too high, the contacts in the humidity sensor close to allow the dehumidifier to run. If the humidity sensor is defective, the dehumidifier will not run.
How do I reset my Whirlpool dehumidifier?
Empty the water bucket used to gather moisture removed from the air down the sink and return it to the appliance. Disconnect the power cord from its electrical outlet and wait five minutes before plugging the dehumidifier back in. The appliance should reset, clearing any settings programmed into the controls.
Why did my dehumidifier stop working?
The culprit could be a dirty fan or a broken fan blade. If comfortable checking inside the unit, unplug it and then remove the cover, then turn the fan blade by hand to see if either debris or a broken blade is keeping the fan from turning.
Why does my dehumidifier fill the bucket when the hose is attached?
There are many reasons why your dehumidifier is not draining through the hose, the most common reason is a clogged hose or has bends, also if the end of the hose is too high, the bucket is full, the end of the hose is standing in water, or there could be an improper connection of the hose adapter.
How do I clean the air filter on my Whirlpool dehumidifier?
see whether it needs cleaning.
- Turn off dehumidifier.
- Remove bucket.
- Pull filter down from below front louvers.
- Pull bottom edge of air filter toward you to clear the bottom of.
- Use a vacuum cleaner to clean air filter.
- Slide air filter up into the dehumidifier.
- Reinstall bucket.
- Turn on the dehumidifier.
Do you have to change filter on dehumidifier?
How often do I need to change the air filter on my whole-home dehumidifier? If your dehumidifier has a built-in filter, Honeywell recommends replacing it every 12 months. Contact your local HVAC professional for your new filter.